Moving into my first house, I realized how little furniture we really had and how expensive it can be to furnish. Right now I’m trying to focus on buying things we don’t already own, and refreshing the hand-me-downs we do have. On my agenda today, our kitchen table!
Our total kitchen can only be described as BEIGE. As in beige walls, countertops, floors, and even appliances (until we eventually upgrade). I’m trying to bring in some color and life through prints, fabrics, and plants until I can add a little depth with the permanent surfaces.
We have a kitchen table which is in pretty good condition. It’s a hand-me-down, but the fabric on the chairs has definitely seen better days. I’m sure it could be cleaned to look better, but the dinginess and color (yep, beige), was a makeover project I was willing to take on.
It’s actually quite easy to give an old chair, bench, or ottoman a completely new look by simply recovering them with new fabric…and this method doesn’t require sewing because it’s just the seat! I admit this was my first attempt at recovering a chair using a staple gun, but seriously it was super easy. Even if you don’t have a DIY bone in your body, I’m sure you could pull this off. Here’s how….
First, figure out how much yardage you need and where you want the pattern to fall on the seat. I think I accounted for 1 yard per seat (taking the pattern into account), but I also found this handy pattern yardage calculator you could use.
Next, the tools to do the job. You can find a staple gun at any home improvement store, and the fabric I picked out was an HGTV Home fabric called Turtle Shell found at Joann Fabric. It’s on sale too! I know it’s a little loud, but I knew it would definitely liven up the space.
First, unscrew the seats from the base. I ended up using a power drill to unscrew because the screwdriver wasn’t strong enough.
Next, place the seat upside down on top of the fabric, taking into account where you want the pattern to be centered on the seat. You can leave the existing fabric on the seat and work around it. Leave at least a 4″ border around the seat and cut out your square.
Pull the fabric tight around the edges, leaving the corners lose. I found it was easiest to start at the top (stapling multiple times across the length of the seat), then pull from the opposite side (bottom). The repeat the other sides until it looks like this….
Next is the trickest part. The corners. You want to make sure you pull these really tight to get a finished look. Start by pulling the fabric in closer from the edges towards the corner, and stapling in place. Then take the remaining fabric and fold like the picture below, and pull extremely tight. Then staple in place as well.
*Note, you may need to cut off some excess fabric to make this easier. If you have too much fabric, it will be bulky, harder to pull tight, and harder to staple.*
The finished back should look like this…
And the front like this!
What do you think of the finished results? Have you ever recovered anything using a staple gun?